Blue Seal GT46 Service Manual download pdf (Page 10)

Installation

Blue Seal Evolution Series GT45 / GT46 / GT60 © Moffat Ltd, January 2007

Revision 1/

4. All air for burner combustion is supplied from underneath the appliance. The legs must always be

fitted and no obstructions placed on the underside or around the base of the appliance, as

obstructions will cause incorrect operation and/or failure of the appliance.

5. Components having adjustments protected (e.g. paint sealed) by manufacturer are only allowed to

be adjusted by an authorised service agent. They are not to be adjusted by the installation person.

NOTE: Do not obstruct or block the appliances flue. Never directly connect a ventilation system to

the appliance flue outlet.

Clearances

NOTE:

• Only non-combustible materials can be used in close proximity to this appliance.

•

In order to facilitate easy operation, drainage and servicing of the appliance, a

minimum of 600mm clearance should be maintained at the front of the appliance.

Any gas burning appliance requires adequate clearance and ventilation for optimum and trouble-free

operation. The following minimum installation clearances are to be adhered to:

Assembly

This model is delivered completely assembled. Ensure that the legs are securely attached.

NOTE:

•

This appliance is fitted with adjustable feet to enable the appliance to be positioned

securely and level. This should be carried out on completion of the gas connection.

Refer to the “Gas Connection” section below.

Optional Accessories (Refer to Replacement Parts List)

•

Plinth Kit. For installation details, refer to the instructions supplied with each kit.

Gas Connection

NOTE: ALL GAS FITTING MUST ONLY BE CARRIED OUT BY A QUALIFIED SERVICE PERSON.

1. Blue Seal Fryers do not require an electrical connection, they function totally on the gas supply only.

2. It is essential that the gas supply is correct for the appliance to be installed and that adequate

supply pressure and volume are available. The following checks should therefore be made before

installation:-

a. The Gas Type the appliance has been supplied for is shown on

coloured stickers located above the gas entry point and next to

the rating plate. Check that this is correct for the gas supply

the appliance is being installed for. The gas conversion

procedure is detailed in this manual.

b. Supply Pressure required for this appliance is shown in the

“Specifications” section of this manual. Check the gas supply to

ensure that adequate supply pressure exists.

c. Input Rate of this appliance is also stated on the Rating Plate

fitted to the inside of the access door and in the

“Specifications” section of this manual. The input rate should

be checked against the available gas supply line capacity.

Particular note should be taken if the appliance is being

added to an existing installation.

Rating Plate

Location

Combustible Surface Non Combustible Surface

Left/Right hand side 50 mm 0 mm

Rear 50 mm 0 mm

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 52 53

Comments to this Manuals

No comments

Blue Seal GT46 Service Manual Page 10

Comments to this Manuals

Related products and manuals for Deep fryers Blue Seal GT46