232423-5 GAS COOKTOP Series G512 G514 G516 G518 INSTALLATION AND OPERATION MANUAL
8 Dimensions Dimensions for Refrigerated Base Models G512 and G514 models - not available in Refrigerated Base option. G516-RB G518-RB Refer to Page 9
9 Dimensions Cooktop Options G512-D G514-D G518-D G518-C G518-B G518-A G516-D G516-C G516-B G516-A G512-C G514-C G514-B NOTE: • G512 models are only
10 Installation Requirements NOTE: • It is most important that this Cooktop is installed correctly and that operation is correct before use. Install
11 Installation Clearances NOTE: Only non-combustible materials can be used in close proximity to this appliance. * Side clearances can be 50mm when
12 Gas Connection NOTE: ALL GAS FITTING MUST ONLY BE CARRIED OUT BY A QUALIFIED PERSON. 1. Blue Seal Cooktops do not require electrical connection,
13 Commissioning Before leaving the new installation; Check the following functions in accordance with the operating instructions specified in the ‘Op
14 Operation Operation Guide 1. Blue Seal appliances have been designed to provide simplicity of operation and 100% safety protection. 2. Improper o
15 Open Burners ('F' - Flame Failure Option) Lighting the Open Burners Flame Failure Protection is incorporated for each burner by way of a
16 Griddle Lighting the Griddle a. Depress the gas control knob and rotate anti-clockwise to the ‘PILOT’ position. b. With the gas control knob dep
17 General Clean the Cooktop regularly. A clean Cooktop looks better, will last longer and will perform better. Carbonised grease on the surface or
The reproduction or copying of any part of this manual by any means whatsoever is strictly forbidden unless qualified previously in writing by the man
18 Daily Cleaning 1. The spill tray(s) should be checked and emptied frequently to prevent overflow and spillage. Remove the spill tray(s) while sti
19 Trivets and Burners a. Remove the trivets from the top of the appliance, taking note that the trivets are manufactured with a lip on one edge, the
20 NOTE: It is imperative that the trivet supports are correctly re-fitted to the appliance to ensure that the trivets locate correctly and sit flush
21 Fault Finding This section provides an easy reference guide to the more common problems that may occur during the operation of your equipment. The
22 Conversion Procedure NOTE: • These conversions should only be carried out by qualified persons. All connections must be checked for leaks before
23 11. Refit all the trivet supports to the top of the appliance. Note the orientation of the trivet support when re-fitting as the front end side
24 • For the Refrigerated Base Model, the Rating Plate is located inside the right hand front panel and can be viewed through the upper grille. Refe
25 Griddles Pilot Burner a. With the gas supply turned off at the main supply, remove the griddle plate section by lifting it straight off the Cookto
26 Gas Conversion and Specifications Gas Regulator - NAT Gas / LPG / Butane Only. NOTE: The regulator supplied is convertible between Natural Gas and
27 Gas Type Labels On completion of the gas conversion, replace gas type labels located at:- - The rear of the unit, above the gas connection. - Besid
1 Blue Seal Gas Cooktops G512 Gas Cooktop 300mm wide. G514 Gas Cooktop 600mm wide. G516 Gas Cooktop 900mm wide. G518 Gas Cooktop 1200mm wide.
28 Gas Conversion and Specifications Gas Specifications (*) NOTE: • The burner operating pressure is to be measured at the manifold test point with t
29 Replacement Parts List When ordering replacement parts, please quote the part number and the description as listed below. If the part required is
30 General 227014 Pot Stand / Trivet. 230286 Spill Tray 300mm (G512 Series). 230277 Spill Tray 600mm (G514 / G518 Series). 230273 Spill Tray 450
31
32
2 2 Introduction We are confident that you will be delighted with your BLUE SEAL COOKTOP, and it will become a most valued appliance in your commerci
3 Specifications Model Numbers Covered in this Specification G512D-[1]-[2] 2 Open Burners. G512C -[2] 300mm Griddle. G514D-[1]-[2] 4 Open
4 Specifications Gas Connection Gas supply connection point is located at the rear of the appliance, approximately 130mm from the right hand side, 32m
5 Dimensions Dimensions for Bench Models G512-B G514-B G516-B G518-B Refer to Page 9 for Cooktop options = Rating Plate Location for this option. R R
6 Dimensions Dimensions for Cabinet Base Models G512 models - not available in Cabinet Base option. G514-CB G516-CB G518-CB Refer to Page 9 for Cookto
7 Dimensions Dimensions for Leg Stand Models G512 models - not available in Leg Stand Base option. G514-LS G516-LS G518-LS Refer to Page 9 for Cooktop
Comments to this Manuals